Stated with mounting the front fender. (Needed to make some brackets)
The first thought was to make a 180 degrees front fender from a rear bicycle fender, but that was too small. (It did not look all right)
So went back to the original plan to use the Motom fender so it has a known look.
The first idea.
34mm clamps.
Starting with the bracket, first drawings.
Start cutting.
Start with the other side.
Draw.
Cut and mount on other.
Ther you go, two brackets.
Mounted.
With mounting holes.
Other side too.
Spacers.
Not bad at all.
Perhaps not the best solution, but it will need to do the job.
Amd with me on it.