An other challenge will be to make the gear shifter.
I don't have much space at the steps so need to construct it somewhere in front.
Think of placing it around here.
Want to cover up this hole with the gear shifter.
Slowly start cutting
Cut the whole piece off.
Cut it in the bent of the holder.
Done
The cut out.
Done.
It came out good.
Cut the part of the chain holder.
Positioned the gear level and tack it in its place.
Also cut the lower part of the frame, as it won't need it.
The end result is not bad, still needs a bid work but roughly its ready.
Pedal distance is a bid large, but my rear steps are also shorter so it will work ok like this.
Think it will be good to go.